SETUP SHEET FOR THE RC10GT

 date: 5-9-99 driver: Greg Degani   
track: Hot Rod Hobbies, Saugus, CA  event: 1999 Reedy Truck Race
TIRE/WHEEL Front Rear SHOCKS Front Rear
Tire Blade Holeshot Shock length 1.02 1.32
Tire compound M2 M2 Body, gray gray gray
Wheel 1-pc 1-pc Shaft length, unobtainium 1.02 1.32
Foam Insert firm firm Travel limiter inside, 1 thin inside, 2 thin
Camber 1.5º -3º Piston #2 #1
Toe-in 4º (Losi 1º hubs) Oil 35wt 30wt
Ride height arms level bones level Spring silver silver
Front caster: 30° Wheelbase: short
Clutch shoes,
# used: 4

Clutch shoes cut: at second hole from end

Rear bulkhead

lower inside hole
Front Shock Position

outside hole

Rear Shock Position

next to outside hole

Ackerman:
STD
Chassis: blue chassis Front A-arm

outside hole
Rear A-arm

outside hole
OTHER INFO: ENGINE INFO:
Driveshafts: MIP CVD's Engine: TOP .12 (Sav-on Hobbies)
non pull start
Bump steer spacers: 3 Fuel: O'Donnell Nitro: 20%
Body: Pro-Line
spoiler: yes
Carburetor type: O.S. 10E
rotary
Slipper setting: tighter Carb restrictor: .190
32-pitch clutch bell, # teeth: 15T Glow plug type: MC 59
bearing clutch Engine temp.: 240º
spur, tooth: 66T Muffler type: Assoc tuned pipe
radio: Futaba 3PS servo: 9450 Digital
Off Road Track Conditions:
Surface: smooth. Traction: high.
Hard dirt, light sand. Dry.
Race Comments:
A-Main, 1st place
Truck Comments:
Moved steering servo and gas tank 3/4" forward (increased corner speed). Also put 1 glow plug washer under front screw of each rear suspension mount for anti-squat (about 1.5 degrees) for increased corner speed (for small tracks only).

5/13/99